Dishwasher Upper Rack Adjuster Kit (Left & Right) (Whirlpool OEM)

Description

Genuine Whirlpool OEM Dishwasher Upper Rack Adjuster Kit (Left & Right) – Part W10712395

Part Number: W10712395

Replaces: AP5957560, W10250159, W10350375, PS10065979, 3516330

Always verify compatibility using your appliance model number before ordering.

Restore full adjustability, smooth gliding motion, and heavy-load support to your upper dishrack with this Genuine OEM Whirlpool Dishwasher Upper Rack Adjuster Kit. Measuring 12.09″ L x 5.31″ W x 5.91″ H and weighing 2.73 lbs, this complete redesign kit upgrades former failure-prone plastic adjuster arms to heavy-duty metal positioners and brackets for long-lasting durability.

Mounted on the left and right outer sides of the upper rack basket, this assembly locks the dishrack into high or low positions to make room for taller glasses on top or oversized cookware below.

If this part fails, plastic clip housings snap, metal adjuster tabs bend, or wheel assemblies break off. This leads to common operating issues, including the top rack sagging on one side, dropping down during wash cycles, jamming when pulled out, or leaving upper dishware improperly cleaned due to misaligned spray arm heights.

Quick Info Compatibility: Precision-engineered for Whirlpool, KitchenAid, Kenmore / Sears, Maytag, JennAir, Amana, and Admiral built-in dishwashers. Advanced Features: Upgraded metal housing construction, dual-side replacement kit (services both left and right sides), smooth-rolling track wheels, and heavy-duty thumb actuators. Fixes Common Issues: Resolves top rack sagging or crooked placement, broken wheel brackets, rack jamming on side rails, and failure to lock in the upper position. Difficulty: Novice. A straightforward 15-to-30 minute DIY repair requiring basic tools (T15 Torx driver/bit and flat-blade screwdriver).

💡 Critical Diagnosis & Prevention Tip: Replace both left and right assemblies at the same time and inspect track stops! Pro Tip: Because Whirlpool upgraded the design from plastic to metal, mixing old plastic components on one side with the new metal kit on the other creates uneven weight distribution and alignment issues. Always install both left and right adjuster assemblies included in the kit simultaneously. Before pulling the rack completely out, carefully release the front plastic rail track end-caps using a small flat-blade screwdriver—do not force or break them, as you will reuse these original track stops to lock the new rack assembly back into place!

Step-by-Step Replacement Guidelines

1. Preparation: Unplug the dishwasher or disconnect power at the main home circuit breaker for safety. Open the dishwasher door and remove any dishes from the upper rack.

2. Remove the Upper Rack: Pry open or unlatch the plastic track stops at the front of both left and right upper slide rails. Carefully slide the entire upper dishrack completely out of the cabinet and set it on a clean work surface.

3. Disassemble Old Adjuster Parts: Use a flat-head screwdriver or T15 Torx tool to unclip/unscrew the old housing covers, levers, and plastic wheel brackets from the rack wires. Discard all old adjuster components.

4. Assemble the New Metal Kit: Position the new long plastic backing housing against the inner wire grid of the upper rack. Slide the upgraded metal adjuster arm and wheel assembly into place from the outside, attach the actuator lever, and secure the outer cover using the provided retaining screws/clips. Repeat the process on the opposite side.

5. Reinstall the Rack: Align the new wheels into the left and right cabinet slide rails, push the rack back into the tub, snap the front rail track stops firmly back into position, and test the height adjustment levers on both sides.