Refrigerator Ice Maker Kit (GE OEM)

Description

Genuine GE OEM Refrigerator Ice Maker Kit – Part WR30X10093

Part Number: WR30X10093

Replaces: AP3672963, PS966219

Always verify compatibility using your appliance model number before ordering.

E Refrigerator Electronic Ice Maker Assembly (WR30X10093)

Restore a reliable, fully automated supply of ice to your kitchen with this Genuine OEM Electronic Ice Maker Assembly. This premium replacement module (Part # WR30X10093) is a factory-certified GE component designed to manage the entire ice production loop. It automatically regulates water fill levels, monitors freezing progress, and triggers an integrated mechanical harvest rake to dump clean ice directly into your storage bucket.

If your refrigerator has completely stopped making ice, produces hollow or undersized cubes, leaks water into the ice bin, or makes a loud clicking or buzzing noise without cycling, the internal timing gears or the mold heater loop inside the module have failed. Manufactured directly by GE, this kit comes complete with the electronic control module, a 4-pin round wire harness connector, a 4-pin flat adapter plug, and the shut-off feeler arm to accommodate both older mechanical styles and modern electronic platforms.

Quick Info:

• Compatibility: Precision-engineered for GE (General Electric), Hotpoint, Haier, Monogram, and Café refrigerators.

• Fixes Common Issues: Resolves “no ice” conditions, jammed or frozen ejector blades, leaking water in the freezer compartment, and ice makers that won’t stop producing.

• Included Components: Includes (1) Electronic 8-Cube Ice Maker Module, (1) Removable Shut-Off Feeler Arm, (1) 4-Pin Flat Wiring Harness Adapter, and installation hardware.

• Difficulty: Novice to Intermediate. A highly straightforward DIY repair typically requiring less than 20 minutes with a nut driver.

Pro Tip: This specific GE assembly is an electronic update designed to replace older mechanical ice makers. Because it is an electronic module, it does not use a physical thermal fuse wire like legacy models did. If you are retrofitting this to an older refrigerator that used a 4-pin flat wall connector, use the included flat-to-round adapter harness bundled in the kit to bridge the connection securely.

Installation & Safety Steps:

1. Isolate Power: You must completely unplug the refrigerator or shut off the main house circuit breaker before starting.

2. Remove the Old Unit: Slide out the ice storage bin. Loosen the two upper mounting screws on the freezer wall, lift the old module up and off the screws, and unplug the wire harness from the wall socket.

3. Configure the Harness: Plug the appropriate wire harness (either direct or using the included adapter) into the freezer wall until it clicks.

4. Mount the New Assembly: Align the rear water inlet funnel with the freezer’s fill tube, hang the module back onto the mounting screws, and tighten them down flush.

Are you replacing this today because your old ice maker has a broken plastic rake blade, or has it stopped filling with water altogether?