Dishwasher Door Hinge Cable Assembly (LG OEM)

Description

Genuine LG OEM Dishwasher Door Hinge Cable Assembly – Part 4933DD3001B

Rope and plastic connector assembly. Connects door hinge to spring; prevents door from dropping fast. Sold individually – often need 2.

Part Number: 4933DD3001B

Replaces: AP4511304, 1395107, 4933DD3001A, AH3524406, EA3524406, PS3524406

Always verify compatibility using your appliance model number before ordering.

LG Dishwasher Door Hinge Cable Assembly (Part # 4933DD3001B)

Restore smooth, controlled door movement and prevent sudden heavy door drops with this Genuine OEM LG Dishwasher Door Hinge Cable Assembly. This essential structural balance component works in tandem with the door spring to provide counterweight tension, allowing the heavy dishwasher door to lower gently and stay safely open at any angle.

Connected between the bottom hinge link of the dishwasher door and the counterbalance spring attached to the side base frame, this high-strength braided cord features durable molded plastic end terminals. Every time the door is opened or closed, the cable glides across a pulley wheel, transferring spring tension to support the weight of the stainless steel door panel and inner rack assembly.

If this part fails, the braided line can fray, snap from continuous friction, or break off at the plastic end connectors. Common failure symptoms include the dishwasher door dropping heavily or falling rapidly toward the floor when unlatched, feeling uncharacteristically heavy to lift, resting unevenly or crooked when open, or making a loud snapping sound behind the lower kickplate.

Quick Info

• Compatibility: Precision-engineered for select LG and Kenmore/Kenmore Elite built-in dishwashers.

• Advanced Features: Heavy-duty braided synthetic cord, impact-resistant molded plastic end connectors for spring and hinge attachment, and low-friction glide design.

• Fixes Common Issues: Resolves dishwasher doors slamming down or dropping too fast, excessive door weight during opening/closing, broken tension cables, and uneven door opening angles.

• Difficulty: Novice to Intermediate. A straightforward DIY repair requiring a screwdriver, pair of pliers, and about 20 to 30 minutes of installation time.

💡 Critical Diagnosis & Prevention Tip

Dishwasher door hinge cables almost always operate in pairs! If one cable snaps due to wear and tear, the remaining cable instantly takes on double the load weight, causing it to stretch, weaken, and fail shortly after.

Pro Tip: It is highly recommended to replace both door hinge cables simultaneously to ensure balanced tension, smooth door operation, and prevent premature wear on your dishwasher’s hinge mechanism. Also, inspect the plastic door cable pulleys while installed—if a pulley is grooved or cracked, it can fray your new cable in no time!

Step-by-Step Replacement Guidelines

1. Safety & Utilities: Disconnect power to the dishwasher at the main circuit breaker panel, and turn off the water supply valve under the sink for safety.

2. Expose the Counterbalance System: Remove the screws securing the lower front access kickplate/toe-kick panel to reveal the space beneath the tub frame. (Note: Depending on your cabinet fit, you may need to unbolt the top mounting brackets and pull the dishwasher forward 3–4 inches).

3. Unhook the Failed Cable: Locate the door spring along the side rail near the bottom frame. Unhook the damaged cable’s plastic end terminal from the tension spring, then unhook the opposite end from the door hinge arm attachment point.

4. Route the New Cable: Snap the plastic clip end of the new OEM cable onto the door hinge link. Route the braided cord smoothly over the plastic pulley wheel guide along the side frame.

5. Attach and Test: Attach the remaining plastic terminal loop of the cable securely onto the end of the counterbalance spring. Open and close the dishwasher door a few times to test for smooth, balanced tension before resecuring the kickplate panel and restoring power.