Samsung Refrigerator Ice Maker Assembly – Half-Moon Cubes (4-Door FlexZone / French Door) (Samsung OEM)

Description

Genuine Samsung OEM Samsung Refrigerator Ice Maker Assembly – Half-Moon Cubes (4-Door FlexZone / French Door) – Part DA97-15217D

Part Number: DA97-15217D

Replaces: DA97-15217A, DA97-15217B, DA97-15217E, DA97-12317A, DA97-12317B, DA97-15335A, AP6261445, 4546148, PS12115595

Always verify compatibility using your appliance model number before ordering.

amsung Refrigerator Ice Maker Assembly (Part # DA97-15217D)

Restore a highly efficient, automated supply of ice to your kitchen with this Genuine OEM Samsung Ice Maker Assembly. This premium replacement factory module (Part # DA97-15217D) is an official factory-certified component designed to manage your refrigerator’s complete ice production loop. It automatically regulates water fill intervals, monitors real-time freezing progress via an integrated thermistor sensor, and initiates a mechanical harvest twist to cleanly drop fresh cubes directly into your storage bucket.

Manufactured directly by Samsung, this complete assembly is built with an integrated electronic control head, a flexible multi-cube twist-mold tray, and the factory pre-wired electrical connection harness. If your refrigerator has completely stopped making ice, produces broken or hollow cubes, leaks water directly into the ice bin, or makes a loud clicking or popping noise without cycling, the internal mechanical timing gears or calibrated temperature sensors inside the module have failed.

Quick Info:

• Compatibility: Precision engineered exclusively for Samsung French-door and side-by-side refrigerators (commonly utilized in modern high-capacity models).

• Fixes Common Issues: Resolves “no ice” conditions, jammed or cracked harvest twist trays, overfilling or water leaking in the ice room, and ice makers that refuse to complete an automated cycle.

• Included Components: Includes (1) Complete Electronic Multi-Cube Ice Maker Module with integrated twist tray, structural housing cover, and a pre-assembled wiring harness.

• Difficulty: Novice to Intermediate. A highly accessible DIY repair typically requiring only a single Phillips screwdriver and about 15 minutes of installation time.

Pro Tip: Before removing your old unit, try executing a manual diagnostic test loop. Locate the tiny rectangular Test Button positioned on the front or side edge of the ice maker’s plastic housing cover, and press and hold it firmly for 3 to 5 seconds. The unit should emit an electronic chime and begin a slow mechanical harvest twist cycle. If the motor rotates completely during this diagnostic test but still refuses to make ice automatically during normal daily operation, your issue is likely either a defective internal temperature thermistor or a freezing compartment that is failing to sustain an optimal cooling climate below 10°F (-12°C).

Installation & Safety Steps:

1. Isolate Power: You must completely unplug the refrigerator’s power cord from the wall outlet or shut off the main house circuit breaker before handling the electrical connectors.

2. Remove the Storage Bin: Open your freezer door or left-side ice compartment and completely slide out the ice collection bucket.

3. Unbolt and Unplug: Locate the securing screws on the front plastic support trim or ceiling tracks. Unthread the screws, slide the old module forward to unhook it from the cabinet rails, and press the locking tab on the electrical wire harness to disconnect it from the wall socket.

4. Mount the New Assembly: Plug the new genuine Samsung wire harness firmly into the wall socket until it clicks securely. Align the new module with the ceiling tracks and slide it back into position. Secure it with the mounting screws and verify that the rear water inlet tube drops cleanly into the fill cup.

Are you replacing this assembly today because the plastic tray itself cracked and is leaking water, or has the drive motor stopped spinning completely?